Kumihimo and Wire

Typically when I use wire for my kumihimo work, I use 20 gauge plated copper. If you are familiar with wire and done any work with it you know that 20 gauge is right on the edge of the readily finger malleable gauges. Getting ‘perfect’ tension with this gauge is always a challenge and you must be ready to show the wire (after acknowledging it superiority) who really is the boss!

On a traditional maru dai shorter lengths can be mastered. For longer pieces, however, the need to readjust the counterweight often leads to unwanted bends in the wires or a misaligned braid and always a few tension issues. A solution presented to our local weaving group a few months ago for another problem led me to my solution. I just needed a much taller mau dai with a few added features and I was on my way.

I am very pleased with the braids shown. The tension in both comes close to rivaling braids of silk.

P.S. These braids are in the Member’s exhibit at the Contemporary Handweavers of Texas (www.weavetexas.org) June 2nd thru June 4th at the Sugar Land Marriott hotel.

Advertisements

Getting Back To It

May 9 2017 013

Crepe de Chine

Been busy this spring focusing on things other than my botanical printing. Have printed a few since the end of last year but some of them ended up looking like I had completely lost my ‘mojo’. The leaves I had dried or frozen just didn’t look like they were coming through for me. There were a few gems, however, that I was very pleased with.

May 9 2017 012

Silk Habotai

May 9 2017 015

Silk Habotai

May 9 2017 028

Crepe de Chine

May 9 2017 022

Silk Habotai

I just started using crepe de chine. I like the softness of print that you can get with silk chiffon but sometimes it is too soft. Crepe de chine still results in soft images but they are a bit bolder.

Also acquired some silk charmeuse. Have printed one and am very pleased. It is still resting before the wash. Will post the results later.